NOTE: Position of the switch is different depending on the model.
3.
All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
1.
CMBS OFF Switch - Test
1.
Check for continuity between CMBS OFF switch 10P connector terminals in each switch position according to the table.
If the continuity is not as specified, replace the CMBS OFF switch.
2.
Check the LED for illumination when connecting battery power and ground to the switch terminals according to the table.
NOTE: Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).
If the results are not as specified, replace the CMBS OFF switch.
