Rear Brake Disc Removal and Installation

NOTE: Review the Service Precautions before doing repairs or service.

1.	Vehicle - Lift

2.	Rear Wheel - Remove

3.	Parking Brake - Release

4.	Brake Caliper - Remove

Remove the caliper assembly without disconnecting the brake hose from the caliper body.

5.	Brake Disc - Remove

Remove the brake disc flathead screw (A).

Remove the brake disc (B).

NOTE: If the brake disc is stuck to the hub bearing unit, thread two 8 x 1.25 mm bolts (C) into the brake disc to push it away from the hub bearing unit. Turn each bolt 90 degrees at a time to prevent the brake disc from binding.

6.	All Removed Parts - Install

Install the parts in the reverse order of removal.

7.	Rear Brake Disc Runout - Inspect

8.	Parking Brake - Adjust

Turn the vehicle to the ON mode.

Apply the parking brake, then release the parking brake.

Turn the vehicle to the OFF (LOCK) mode.