Electric Parking Brake Actuator Removal and Installation

1.	Vehicle - Lift

2.	Rear Wheel - Remove

3.	Electric Parking Brake Actuator - Remove

1.

Disconnect the connector (A).

NOTE: If the connector lock tab is difficult to release, push in on the connector body before pushing on the release lock.

2.

Remove the electric parking brake actuator (B).

NOTE:

Use new mounting screws (C) during reassembly.

During installation, coat the spindle (D) with the actuator service set grease.

3.

Remove the O-ring (E) from the caliper body (F).

NOTE:

Replace the O-ring whenever the electric parking brake actuator is removed.

When installing the actuator, make sure there is no foreign matter on the mating surfaces and the O-rings before installing.

4.	All Removed Parts - Install

1.

Install the parts in the reverse order of removal.

5.	Electric Parking Brake Actuator After Install - Check

1.

Turn the vehicle to the ON mode.

2.

Apply and release the parking brake 2 times, then make sure that the brake system indicator (red) goes OFF.

NOTE: If the brake system indicator (red) does not go OFF, check for poor connection at the electric parking brake actuator connector.

3.

Turn the vehicle to the OFF (LOCK) mode.