Cylinder Head Inspection for Warpage
1.
Cylinder Head - Remove
2.
Cylinder Head Warpage - Inspect
1.
Check the cylinder head for warpage. Measure along the edges, and three ways across the center:
If warpage is less than 0.08 mm (0.003 in) cylinder head resurfacing is not required.
Maximum resurface limited to the cylinder head height standard as shown.
Warpage
Standard (New):
0.08 mm (0.003 in) max.
Cylinder Head Height
Standard (New):
126.95?127.05 mm (4.9980?5.0020 in)
3.
All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
