Hold the pulley with the holder handle and the crankshaft pulley holder.
2.
Remove the bolt with a socket, 19 mm and a breaker bar, then remove the crankshaft pulley.
1.
Crankshaft Pulley - Install
1.
Remove any oil and clean the crankshaft pulley (A), the crankshaft (B), the bolt (C), and the washer (D). Lubricate with new engine oil as shown.
When a new crankshaft and/or a new pulley bolt is installed
2.
Install the crankshaft pulley and the pulley bolt.
3.
Hold the pulley with the holder handle and crankshaft pulley holder, torque the pulley bolt to 180 N·m (18.4 kgf·m, 133 lbf·ft) with a torque wrench and a socket, 19 mm, then remove the pulley bolt.
4.
Torque the pulley bolt to 50 N·m (5.1 kgf·m, 37 lbf·ft) with a torque wrench and a socket, 19 mm.
NOTE: Do not use an impact wrench.
5.
Tighten the pulley bolt an additional 90 °.
When the crankshaft and the pulley bolt is reused
6.
Install the crankshaft pulley and the pulley bolt.
7.
Hold the pulley with the holder handle and crankshaft pulley holder, then torque the pulley bolt to 50 N·m (5.1 kgf·m, 37 lbf·ft) with a torque wrench and a socket, 19 mm.
