CVT Driven Pulley Pressure Sensor Removal and Installation

NOTE: Keep all foreign particles out of the transmission.

2. CVT Driven Pulley Pressure Sensor - Remove
1.
Disconnect the connector (A).
2.
Remove the CVT driven pulley pressure sensor (B) with the sealing washer (C).
NOTE: Be careful not to damage the plastic part.

3. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
NOTE:
Be sure to use a new sealing washer.
Check the connector for corrosion, dirt, or oil, and clean or repair if necessary.

4. TCM - Reset (Only for Replacing CVT Driven Pulley Pressure Sensor)

NOTE: This procedure is not required, if the CVT driven pulley pressure sensor and the TCM are replaced simultaneously.