Where icon is shown, click for further information.
The bearing and the bearing outer race should be replaced as a set.
1
Detailed information, notes and precautions
Replace
1.
Final Drive Shaft Tapered Roller Bearing - Remove
Transmission Housing Side
Torque Converter Housing Side
1.
Remove the final drive shaft tapered roller bearings (A) using the bearing separator, a commercially available bearing puller (B), and a commercially available spacer (C).
2.
Cotter Retainer - Remove
3.
38 mm Cotter - Remove
4.
Secondary Driven Gear - Remove
1.
Remove the secondary driven gear (A) using a press.
NOTE:
Where icon is shown, click for further information.
The bearing and the bearing outer race should be replaced as a set.
Apply a light coat of clean transmission fluid on all parts before installation.
1
Detailed information, notes and precautions
Replace
1.
Secondary Driven Gear - Install
NOTE: Make sure to assemble the final drive shaft and the final driven gear correctly (Combination A or B) as shown in the chart if either one of them or both are to be replaced. Correct combinations of the shaft and gear can be identified by the presence or the absence of the groove as shown in the chart.
1.
Install the secondary driven gear (A) until it bottoms in the direction shown using a press.
2.
38 mm Cotter - Install
3.
Cotter Retainer - Install
4.
Final Drive Shaft Tapered Roller Bearing - Install
Transmission Housing Side
1.
Install the final drive shaft tapered roller bearing (A) until it bottoms using the 15 x 135L driver handle, the 40 mm attachment, and a press.
Torque Converter Housing Side
2.
Install the final drive shaft tapered roller bearing (A) until it bottoms using the 15 x 135L driver handle, the 45 mm attachment, and a press.
