12 Volt Battery Sensor Removal and Installation

NOTE: Canada models: When turning the vehicle to the ON mode for the first time after the 12 volt battery is reconnected, turn the vehicle to the ON mode while depressing the brake pedal for the immobilizer mutual authentication between the body control module and the VSA modulator-control unit.

1. 12 Volt Battery Sensor - Remove
1.
Make sure the vehicle is in the OFF (LOCK) mode.
2.
Disconnect the connector (A).
3.
Disconnect the cable (B) from the 12 volt battery sensor (C).
4.
Remove the 12 volt battery sensor from the 12 volt battery.
NOTE: To protect the connector (D) from damage, do not hold it when removing the terminal.

1. 12 Volt Battery Sensor - Install
1.
Install the 12 volt battery sensor (A) to the 12 volt battery.
NOTE:
Make sure the areas between the terminal and the 12 volt battery sensor are clean.
To protect the connector (B) from damage, do not hold it when installing the terminal.
2.
Connect the cable (C) on the 12 volt battery sensor.
3.
Connect the connector (D).
4.
Apply multipurpose grease to the terminal to prevent corrosion.