NOTE: It is not necessary to use sealing agent between the housings for this procedure.
4.
Use the 40 mm I.D. driver handle to bottom the differential assembly in the clutch housing.
5.
Measure the clearance between the 90 mm shim and the bearing outer race in the transmission housing.
Standard:
0?0.10 mm (0?0.003 in)
6.
If the clearance exceeds the standard, select a new 90 mm shim from the following table. If the clearance measured in step 5 is within the standard, go to step 9.
90 mm Shim
Type
Thickness
A
1.00 mm (0.0394 in)
B
1.05 mm (0.0413 in)
C
1.10 mm (0.0433 in)
D
1.15 mm (0.0453 in)
E
1.20 mm (0.0472 in)
F
1.25 mm (0.0492 in)
G
1.30 mm (0.0512 in)
H
1.35 mm (0.0531 in)
J
1.40 mm (0.0551 in)
K
1.45 mm (0.0571 in)
L
1.50 mm (0.0591 in)
M
1.55 mm (0.0610 in)
N
1.60 mm (0.0630 in)
P
1.65 mm (0.0650 in)
R
1.70 mm (0.0669 in)
S
1.75 mm (0.0689 in)
T
1.80 mm (0.0709 in)
7.
Remove the transmission housing.
8.
Replace the thrust shim selected in step 6, then recheck the clearance.
