Clutch Hose and Line Inspection

NOTE:
Replace the clutch hose if it is twisted, cracked, and leaks.
Replace the clutch lines if it is damaged, rusted, and leaks.
When attaching the clutch reservoir hose, align the paint mark on the hose to the connector rib on the clutch master cylinder connection area.
When attaching the clutch reservoir hose, align the paint mark on the hose to the connector rib on the clutch reservoir connection area.
Use fender covers to avoid damaging painted surfaces.
Do not spill brake fluid on the vehicle; it may damage the paint or plastic. If brake fluid gets on the paint or plastic, wash it off immediately with water.

1. Clutch Hose and Line - Inspect

Connection Point
Component
Connected to
Specified Torque Value
Note
A
Clutch master cylinder
Clutch pipe A
15 N·m (1.5 kgf·m, 11 lbf·ft)
Flare nut*1
Clutch reservoir hose
    
B
Brake master cylinder
Clutch reservoir hose
    
C
Clutch hose
Clutch pipe A
15 N·m (1.5 kgf·m, 11 lbf·ft)
Flare nut*1
Clutch pipe B
D
Slave cylinder
Clutch pipe B
15 N·m (1.5 kgf·m, 11 lbf·ft)
Flare nut*1