Washer Motor Removal, Installation, and Test
USA models

1. Right Front Inner Fender - Remove


2. Windshield/Rear Window Washer Motor - Remove
1.
Disconnect the connector (A).
2.
Remove the windshield/rear window washer motor (B).
NOTE: Fluid may flow out of the opening.
3.
Remove the grommet (C).
NOTE: Inspect the grommet for damage. If damaged, replace it.

3. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.

Canada models

1. Left Front Inner Fender - Remove


2. Windshield/Rear Window Washer Motor - Remove
1.
Disconnect the connector (A).
2.
Remove the windshield/rear window washer motor (B).
NOTE: Fluid may flow out of the opening.
3.
Remove the grommet (C).
NOTE: Inspect the grommet for damage. If damaged, replace it.

3. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.

1. Windshield/Rear Window Washer Motor - Test
1.
Check the washer motor operation by connecting power and ground according to the table. The motor should run.
If the washer motor does not run or fails to run smoothly, replace the windshield/rear window washer motor (A).
If the washer motor runs smoothly, but little or no washer fluid is pumped, check for a disconnected or blocked washer hose, or a clogged washer motor outlet.