Engine Oil Pressure Switch Removal and Installation

NOTE:
Do not disconnect the suction hose and the discharge hose.
Do not bend the suction hose and the discharge hose excessively.
Hang the A/C compressor with a wire tie.

6. Oil Pressure Switch - Remove
1.
Disconnect the connector (A).
2.
Remove the oil pressure switch (B).
3.
Remove any old liquid gasket from the oil pressure switch and the oil pressure switch mounting hole.

1. Oil Pressure Switch - Install
1.
Apply liquid gasket (P/N 08718-0003, 08718-0004, or 08718-0009) to the oil pressure switch threads. Install the component within 5 minutes of applying the liquid gasket.
NOTE:
Using too much liquid gasket may cause liquid gasket to enter the oil passage or the end of the oil pressure switch.
If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply new liquid gasket.
2.
Install the oil pressure switch (A).
3.
Connect the connector (B).