Transmission Fluid Temperature Sensor Test
1.
Vehicle - Lift
2.
Engine Undercover - Remove (Without Engine Undercover Lid)
3.
Engine Undercover Plate - Remove (With Engine Undercover Lid)
4.
Engine Undercover Lid - Remove (With Engine Undercover Lid)
5.
Transmission Fluid Temperature Sensor - Test
1.
Disconnect the connector (A).
NOTE: To prevent damage, cover the connector using a shop towel.
2.
Measure the resistance between connector (male terminals) (B) terminals No. 6 and No. 7.
Standard:
50 ??25 k?
If the resistance is within the standard, the test is complete.
If the resistance is out of the standard,
replace the transmission fluid temperature sensor
.
6.
All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
NOTE: Check the connector for corrosion, dirt, or oil, and clean or repair if necessary.
