Install the parts in the reverse order of removal.
1.
Integrated Drive-Mode Switch - Test (Si)
1.
Check the switch according to the table.
NOTE:
When an LED is located between terminals, check if the LED illuminates by connecting power and ground to the LED.
Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).
2.
If the result is not as specified, replace the integrated drive-mode switch (A).
2.
Integrated Drive-Mode Switch - Test (Type-R)
1.
Check the switch according to the table.
NOTE:
When an LED is located between terminals, check if the LED illuminates by connecting power and ground to the LED.
Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).
2.
If the result is not as specified, replace the integrated drive-mode switch (A).
