Front Fender Rear Outlet Removal and Installation
2. Front Fender Rear Outlet - Remove
1.
Remove the screw (A) and the clip (B).
2.
Remove the front fender rear outlet (A).

3. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
NOTE : If you are reusing the original front fender rear outlet seal (A), apply the adhesive primer to the area where the new double-sided adhesive tape (B) will be applied, and then attach the new double-sided adhesive tape to the front fender rear outlet seal as shown.
Adhesive tape requirements:
Thickness 0.2 mm (0.008 in)
 
Width 3 mm (0.12 in)
 
Length 555 mm (21.85 in)