Cylinder Head Inspection for Warpage
NOTE: Unless otherwise indicated, illustrations used in the procedure are for K20C2 engine.
1.
Cylinder Head - Remove
2.
Camshaft - Inspect
3.
Cylinder Head Warpage - Inspect
1.
Check the cylinder head for warpage. Measure along the edges, and three ways across the center.
If warpage is less than 0.05 mm (0.002 in) cylinder head resurfacing is not required.
Maximum resurface limited to the cylinder head height standard as shown.
Warpage
Standard (New):
0.05 mm (0.002 in) max.
Cylinder Head Height
Standard (New):
111.95?112.05 mm (4.4075?4.4114 in)
4.
All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
