Clean and dry the transmission end crankshaft oil seal housing.
2.
Apply a light coat of new engine oil to the crankshaft and to the lip of the new transmission end crankshaft oil seal.
3.
Use the driver handle, 15 x 135L and the oil seal driver attachment, 96 mm, to drive a new transmission end crankshaft oil seal (A) squarely into the engine block to the specified installed height.
4.
Measure the distance between the lower block (A) and transmission end crankshaft oil seal (B).
Oil Seal Installed Height:
0.2?1.2 mm (0.008?0.047 in)
5.
Clean the excess oil off the crankshaft, and check that the transmission end crankshaft oil seal lip is not distorted.
6.
All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
