Acceleration Sensor Removal, Installation, and Inspection

NOTE:
How to read the torque specifications.
Do not damage or drop the acceleration sensor as it is sensitive.
Do not use power tools when removing the acceleration sensor.

Front

2. Acceleration Sensor - Remove

3. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.

Rear

2. Acceleration Sensor - Remove

3. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.

2. Acceleration sensor - Inspection
1.
Turn the vehicle to the OFF (LOCK) mode.
2.
Connect the acceleration sensor connector.
3.
Turn the vehicle to the ON mode.
4.
With the HDS, check the following signal in the ADAPTIVE DAMPER SYSTEM DATA LIST by slowly moving the acceleration sensor as shown in the illustration.
Signal
Specified value
FRONT ACCELERATION SENSOR VOLTAGE
About 0.39?4.77 V
RIGHT REAR ACCELERATION SENSOR VOLTAGE
LEFT REAR ACCELERATION SENSOR VOLTAGE
5.
If the voltages do not change or out of specification, replace the acceleration sensor.