Bearing Driver Attachment, 42 x 47 mm 07746-0010300
Bearing Driver Attachment, 52 x 55 mm 07746-0010400
Driver Handle, 15 x 135L 07749-0010000
Support Base 07965-SD90100
Support Base Attachment 07LAF-SM40300
Installer Attachment, 45 x 55 mm 07MAD-PR90100
Where icon is shown, click for further information.
Clean the disassembled parts with solvent, then dry the disassembled parts with compressed air. Do not wash the rubber parts with solvent.
1
Detailed information, notes, and precautions
Replace
1.
Outer Seal - Remove
2.
External Snap Ring - Remove
3.
Intermediate Shaft - Remove
1.
Press the intermediate shaft (A) out of the intermediate shaft bearing (B) using the support base attachment, the support base, and a press.
NOTE: Be careful not to damage the bearing support ring (C) on the intermediate shaft during disassembly.
4.
Internal Snap Ring - Remove
5.
Intermediate Shaft Bearing - Remove
1.
Press the intermediate shaft bearing (A) out of the bearing support (B) using the 15 x 135L driver handle, the 42 x 47 mm bearing driver attachment, and a press.
Where icon is shown, click for further information.
Clean the disassembled parts with solvent, then dry the disassembled parts with compressed air. Do not wash the rubber parts with solvent.
1
Detailed information, notes, and precautions
Replace
1.
Intermediate Shaft Bearing - Install
1.
Press the intermediate shaft bearing (A) into the bearing support (B) using the 15 x 135L driver handle, the 52 x 55 mm bearing driver attachment, and a press.
2.
Internal Snap Ring - Install
3.
Intermediate Shaft - Install
1.
Press the intermediate shaft (A) into the shaft bearing (B) using the support base, the support base attachment and a press.
4.
External Snap Ring - Install
5.
Outer Seal - Install
1.
Install the outer seal (A) into the bearing support (B) using the 45 x 55 mm installer attachment and a press. Press in the seal until it is even with the surface of the bearing support.
