If there is no clearance between the master cylinder piston and the push rod, the release bearing will be held against the diaphragm spring, which can result in clutch slippage or other clutch problems.
Before adjusting the clutch pedal and the clutch pedal position switch, check the clutch pedal and the clutch master cylinder are installed correctly and not damaged.
1.
Clutch Pedal, Clutch Pedal Adjusting Bolt, and Clutch Pedal Position Switch A - Adjust
1.
Loosen the clutch pedal adjusting bolt locknut (A), and back off the clutch pedal adjusting bolt (B) until it no longer touches the clutch pedal (C).
2.
Pull the clutch pedal by hand, then turn in the clutch pedal adjusting bolt until it contacts the clutch pedal.
3.
Turn in the clutch pedal adjusting bolt an additional 3/4 to 1 turn.
4.
Make sure the clutch pedal height did not change.
5.
While holding clutch pedal adjusting bolt tighten the locknut.
6.
Pull back the carpet.
7.
Measure the clutch pedal height (A) from right side middle of the clutch pedal cover (B) to the floor on the tab (C) without the insulation.
(A) Clutch Pedal Height (Reference):
214.8 mm (8.457 in)
8.
Measure the clutch pedal disengagement height (D) from right side middle of the clutch pedal cover to the floor on the tab without the insulation.
