Type B: The park pin switch and the shift lock unit are not available separately. Replace them as a set.
1
Type A
Detailed information, notes and precautions
Torque: N·m (kgf·m, lbf·ft)
Replace
*1
Do not wipe off special grease applied in advance.
*2
Component of shift lock solenoid
2
Type B
Detailed information, notes and precautions
Torque: N·m (kgf·m, lbf·ft)
Replace
*1
Do not wipe off special grease applied in advance.
*2
Component of shift lock solenoid
1.
Front Cover - Remove
NOTE:
Before removing the front cover, slip the shift lever boot ring (A) out of the shift lever knob (B).
The shift lever knob has two lock tabs (C) in the shift lever boot (D) located under the shift lever boot ring ribs (E). To prevent damage of the shift lever knob and the shift lever boot ring, be sure to grasp the lock tabs while slipping the shift lever boot ring.
2.
Shift Lever Knob - Remove
3.
Shift Position Indicator Panel - Remove
4.
Shift Lever Boot - Remove
Type A
Type B
1.
While releasing the lock tabs (A), remove the shift lever boot.
5.
Release Holder - Remove (Type B)
1.
Remove the release holder (A) by expanding the lock tabs (B).
6.
Shift Lock Release - Remove
Type A
1.
While pressing the lock tab (A), remove the shift lock release (B).
Type B
1.
Remove the shift lock release (A) in the following order:
?1.
Press the shift lock release and release the lock tab (B) in the numbered sequence shown.
?2.
Slide the shift lock release and release it in the numbered sequence shown.
7.
Shift Lock Unit - Remove (Type B)
1.
Release the lock tab (A) and turn the pivot pin (B) counterclockwise using a hex wrench (C) as shown, and pull it.
2.
Remove the shift lock unit (D) while releasing four lock tabs (E).
8.
Shift Lock Solenoid/Park Pin Switch - Remove (Type A)
1.
Remove the shift lock solenoid (A) by expanding the lock tab (B).
2.
Remove the park pin switch (C) by expanding the lock tabs (D).
9.
Shift Lock Solenoid - Remove (Type B)
1.
Remove the shift lock solenoid (A) by expanding the lock tabs (B).
10.
Shift Lock Stop/Shift Lock Stop Cushion - Remove
11.
All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
