Release the double-sided adhesive tapes (B), and detach the clips (C), then remove the rear wheel arch protector (D).
3.
All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
NOTE: If you are reusing the original rear wheel arch protector (A), apply adhesive primer to the areas where the new double-sided adhesive tapes (B, C) will be applied, and then attach the new double-sided adhesive tapes to the rear wheel arch protector as shown.
Adhesive tape requirements
(B)
Thickness
0.8 mm (0.032 in)
Width
10 mm (0.39 in)
Length
337 mm (13.27 in)
(C)
Thickness
1.0 mm (0.039 in)
Width
5 mm (0.20 in)
Length
527 mm (20.75 in)
NOTE: Apply the new double-sided adhesive tape as shown.
2.
Fold the edge of each adhesive backing from the double-sided adhesive tapes.
