Front Individual Map Light Removal, Installation, and Test
1. Front Individual Map Light - Remove
1.
Turn the front individual map light switch OFF.
2.
Remove the front individual map light (A).

Without moonroof and ambient light

Without moonroof with ambient light (Type A)

Without moonroof with ambient light (Type B)

With moonroof (Type A)

With moonroof (Type B)
3.
Disconnect the connector(s) (B).
4.
Remove the bulb(s) (C).

2. Ambient Light - Remove (With Ambient Light)

Without moonroof

With moonroof

3. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.

1. Front Individual Map Light - Test

Without moonroof and ambient light

Without moonroof with ambient light

With moonroof
NOTE: When doing the front individual map light test, make sure to install the bulbs correctly.
1.
Check for continuity between the terminals in each switch position according to the table.
2.
If the continuity is not as specified, replace the bulb(s) or the front individual map light (A).