Electric Parking Brake Switch Removal, Installation, and Test
2. Electric Parking Brake Switch - Remove

1.
Remove the electric parking brake/automatic brake hold switch (A)





2.
Remove the automatic brake hold switch (A).

3. All Removed Parts - Install

1.
Install the parts in the reverse order of removal.

1. Electric Parking Brake Switch - Test

Without electric parking brake switch indicator

1.
Check the switch according to the table.

NOTE:
When an LED is located between terminals, check if the LED illuminates by connecting power and ground to the LED.
Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).



2.
If the result is not as specified, replace the switch.





With electric parking brake switch indicator

1.
Check the switch according to the table.

NOTE:
When an LED is located between terminals, check if the LED illuminates by connecting power and ground to the LED.
Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).



2.
If the result is not as specified, replace the switch.