Millimeter Wave Radar Removal and Installation
Special Tools Required
Image Description/Tool Number
9451201.png Adaptive Speed Control Alignment Tool SPX 10243*
16742986.png ADJUSTER, RADAR 3.5MM 07AAA-TGVA100*
* (SPX 10243/07AAA-TGVA100): Adaptive Speed Control Alignment Tool SPX 10243 or ADJUSTER, RADAR 3.5MM 07AAA-TGVA100 can be used.
2. Millimeter Wave Radar - Remove
Millimeter Wave Radar Assembly Removal
1.
Disconnect the connector (A).
2.
Remove the harness clip (B).
3.
Remove the millimeter wave radar assembly (C).
Millimeter Wave Radar Subassembly Removal

NOTE: The millimeter wave radar cannot be disassembled.
1.
Rotate the three clips (A) counterclockwise.
2.
Remove the millimeter wave radar subassembly (B) from the clips.
3.
Remove the clips from the radar bracket (C).

1. Millimeter Wave Radar - Install
Millimeter Wave Radar Subassembly Installation
1.
Install new clips (A) on the radar bracket (B).
2.
Install the millimeter wave radar subassembly (C) on the clips.
3.
Rotate the three clips clockwise to secure the millimeter wave radar subassembly to the radar bracket.
4.
Measure the distance from D to the radar bracket and E to the radar bracket. Both measured values should be within the range of the standard value.
Standard :
approximately 44.8 mm (1.764 in)
Millimeter Wave Radar Assembly Installation
1.
Install the millimeter wave radar assembly (A).
2.
Install the harness clip (B).
3.
Connect the connector (C) while holding the millimeter wave radar assembly.
NOTE: Applying excessive force may deform the radar bracket.