Multipurpose Camera Unit Removal and Installation
1. Camera Cover - Remove
NOTE: When removing the camera cover, take care not to break the camera cover base.
1.
Release the hooks (A), then remove the camera cover lid (B).
2.
Remove the camera cover (C).

2. Multipurpose Camera Unit - Remove
NOTE: Do not touch the lens part of the multipurpose camera unit.
1.
Disconnect the connector (A).

2.
Pull back the multipurpose camera unit (B) to remove it while supporting the camera bracket rib (C) and the front part of the multipurpose camera unit by hand as shown in the figure.

1. Multipurpose Camera Unit - Install
1.
Install the multipurpose camera unit (B).
NOTE: Visually check that the tabs (C) on both sides of the multipurpose camera unit are inserted into between the camera bracket (D) and spring A.

2.
Connect the connector (E).

2. Camera Cover - Install
1.
Install the camera cover (A).
2.
Install the camera cover lid (B).