Resetting the Parking and Back-Up Sensor Control Unit

Reset the parking and back-up sensor control unit after doing any of the following actions:
When you replace the parking and back-up sensor.
When you change the parking and back-up sensor mounting location from the original location.

NOTE: Before performing the resetting procedure, make sure that each parking and back-up sensor is connected.

1. Parking and Back-Up Sensor Control Unit - Reset

Resetting Procedure
1.
Turn the vehicle to the ON mode.
2.
Press the parking and back-up sensor button 10 times, within 10 seconds.
NOTE: The parking and back-up sensor switch indicator will blink.
3.
Turn the vehicle to the OFF (LOCK) mode.
4.
Press and hold the parking and back-up sensor button.
5.
Turn the vehicle to the ON mode.
6.
Wait about 10 seconds.
NOTE: If the resetting procedure is successful, the parking and back-up sensor buzzer will sound for 2 seconds.
7.
Press the parking and back-up sensor button.
8.
Make sure that the system works normally.