|
DTC Troubleshooting: B1176
DTC B1176: Fuel Level Sensor (Fuel Gauge Sending Unit) Circuit Short
|
DTC Description |
DTC |
|
B1176 Fuel Level Sensor (Fuel Gauge Sending Unit) Circuit Short |
| |
|
|
1. |
Problem verification:
Problem verification
|
?1. |
Clear the DTCs with the HDS.
|
|
?2. |
Turn the vehicle to the OFF (LOCK) mode. |
|
?3. |
Turn the vehicle to the ON mode, and wait more than 30 seconds. |
|
?4. |
Check for DTCs with the HDS.
|
DTC Description |
DTC |
|
B1176 Fuel level sensor (Fuel gauge sending unit) circuit short |
| |
| | |
Is DTC B1176 indicated?
|
|
|
|
|
|
|
Intermittent failure, the system is OK at this time. Check for loose or poor connections.? |
|
2. |
Shorted wire check (FUEL GAUGE+ line):
Shorted wire check (FUEL GAUGE+ line)
|
?1. |
Turn the vehicle to the OFF (LOCK) mode. |
|
?2. |
Disconnect the following connectors.
|
Gauge control module connector A (32P)
Fuel tank unit 4P connector | |
| |
|
?3. |
Check for continuity between test points 1 and 2.
|
Test condition |
Vehicle OFF (LOCK) mode
Fuel tank unit 4P connector: disconnected
Gauge control module connector A (32P): disconnected |
|
Test point 1 |
|
|
Test point 2 |
Body ground | |
| | |
Is there continuity?
|
|
|
Repair a short to ground in the wire.? |
|
|
|
The FUEL GAUGE+ wire is OK. Go to step 3. |
|
3. |
Fuel gauge sending unit check:
Fuel gauge sending unit check
|
Is the fuel gauge sending unit OK?
|