Road Departure Mitigation Symptom Troubleshooting - RDM indicator (on the MID) does not come on
RDM indicator (on the MID) does not come on
1.
Gauge control module operation check:

Gauge control module operation check
?1.
Turn the vehicle to the ON mode.

?2.
Check the following indicators in the gauge control module:
Malfunction indicator lamp (MIL)
Brake system indicator
Battery charging system indicator

Do the indicators come on?

     
YES
     
     
     
     
NO
     
     
     
Go to step 2.
2.
Fuse check:

Fuse check
?1.
Turn the vehicle to the OFF (LOCK) mode.

?2.
Check the following fuse.
Fuse
No. B7 (10 A)
Location
Under-dash fuse/relay box

Is the fuse OK?

     
YES
     
     
     
The fuse is OK. Reinstall the fuse, then go to step 3.
     
NO
     
     
     
Replace the fuse. Turn the vehicle to the ON mode, then the OFF (LOCK) mode. If the fuse blows again, repair the short to ground on the No. B7 (10 A) fuse circuit.?
3.
Open wire check (IG1 METER line):

Open wire check (IG1 METER line)
?1.
Disconnect the following connector.
Gauge control module connector A (32P)

?2.
Turn the vehicle to the ON mode.

?3.
Measure the voltage between test points 1 and 2.
Test condition
Vehicle ON mode
 
Gauge control module connector A (32P): disconnected
Test point 1
Gauge control module connector A (32P) No. 17
Test point 2
Body ground

Is there battery voltage?

     
YES
     
     
     
     
NO
     
     
     
Repair an open in the IG1 METER wire between the under-dash fuse/relay box and the gauge control module.?