DTC Troubleshooting: P2138
DTC P2138: APP Sensor A/B (TP Sensor D/E) Incorrect Voltage Correlation
NOTE: Before you troubleshoot, review the general troubleshooting information.

DTC Description
Confirmed DTC
Pending DTC
P2138 APP Sensor A/B (TP Sensor D/E) Incorrect Voltage Correlation
    

1.
Problem verification:

Problem verification
?1.
Turn the vehicle to the ON mode.

?2.
Clear the DTC with the HDS.


?3.
Press the accelerator pedal to the floor.

?4.
Check for Pending or Confirmed DTCs with the HDS.
DTC Description
Confirmed DTC
Pending DTC
P2138 APP Sensor A/B (TP Sensor D/E) Incorrect Voltage Correlation
    

Is DTC P2138 indicated?

     
YES
     
     
     
The failure is duplicated. Go to step 2.
     
NO
     
     
     
Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the APP sensor and the PCM. If the on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the on-board snapshot.?
2.
Determine possible failure area (APP sensor, others):

Determine possible failure area (APP sensor, others)
?1.
Check the parameter(s) below with the HDS.
Signal
Current conditions
Values
Unit
APP SENSOR A
    
APP SENSOR B
    

Are they the same voltage?

     
YES
     
     
     
Go to step 3.
     
NO
     
     
     
3.
Determine possible failure area (PCM, others):

Determine possible failure area (PCM, others)
?1.
Turn the vehicle to the OFF (LOCK) mode.

?2.
Jump the SCS line with the HDS, and wait more than 1 minute.


?3.
Disconnect the following connector.
PCM connector A (50P)

?4.
Check for continuity between test points 1 and 2.
Test condition
Vehicle OFF (LOCK) mode
 
PCM connector A (50P): disconnected
Test point 1
PCM connector A (50P) No. 32
Test point 2
PCM connector A (50P) No. 34

Is there continuity?

     
YES
     
     
     
Go to step 4.
     
NO
     
     
     
Check for any authorized service information related to the DTCs or symptoms you are troubleshooting, or substitute a known-good PCM, then recheck. If DTC P2138 goes away and the PCM was substituted, replace the original PCM.?
4.
Shorted wire check (APS1 line to APS2 line):

Shorted wire check (APS1 line to APS2 line)
?1.
Disconnect the following connector.
APP sensor 6P connector

?2.
Check for continuity between test points 1 and 2.
Test condition
Vehicle OFF (LOCK) mode
 
PCM connector A (50P): disconnected
 
APP sensor 6P connector: disconnected
Test point 1
PCM connector A (50P) No. 32
Test point 2
PCM connector A (50P) No. 34

Is there continuity?

     
YES
     
     
     
Repair a short in the APS1 wire to the APS2 wire between the PCM (A32, A34) and the APP sensor.?
     
NO
     
     
     
The APS1 wire and the APS2 wire are OK. Replace the accelerator pedal module.?