Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.
?4.
Check for DTCs with the HDS.
DTC Description
DTC
Freeze Frame
U3006-13 IG1 Circuit Open
Is DTC U3006-13 indicated?
YES
The failure is duplicated. Go to step 2.
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the Freeze data/on-board snapshot.?
2.
Fuse check:
Fuse check
?1.
Turn the vehicle to the OFF (LOCK) mode.
?2.
Check the following fuse.
Fuse
No. B34 (10 A)
Location
Under-dash fuse/relay box
Is the fuse OK?
YES
The fuse is OK. Reinstall the fuse, then go to step 3.
NO
Replace the fuse. Turn the vehicle to the ON mode, then to the OFF (LOCK) mode. If the fuse blows again, repair a short to body ground in the No. B34 (10 A) fuse circuit.?
3.
Open wire check (IG1 VSA/ABS line):
Open wire check (IG1 VSA/ABS line)
?1.
Disconnect the following connector.
VSA modulator-control unit 46P connector
?2.
Turn the vehicle to the ON mode.
?3.
Measure the voltage between test points 1 and 2.
Test condition
Vehicle ON mode
VSA modulator-control unit 46P connectorr: disconnected
Check for loose terminals and poor connections in the VSA modulator-control unit 46P connector. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the VSA modulator-control unit.?
NO
Repair an open in the wire between the VSA modulator-control unit 46P connector and the under-dash fuse/relay box.?