DTC Troubleshooting: C1130-54, C1130-76
DTC C1130-54: Clutch Stroke Sensor Not Calibrated
DTC C1130-76: Clutch Pedal Stroke Sensor Mount Position Error
NOTE: Before you troubleshoot, review the general troubleshooting information.

DTC Description
DTC
Freeze Frame
C1130-54 Clutch Stroke Sensor Not Calibrated
    
C1130-76 Clutch Pedal Stroke Sensor Mount Position Error
    

1.
Problem verification:

Problem verification
?1.
Turn the vehicle to the ON mode.

?2.
Clear the DTC with the HDS.


?3.
Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.

?4.
Check for DTCs with the HDS.
DTC Description
DTC
Freeze Frame
C1130-54 Clutch Stroke Sensor Not Calibrated
    
C1130-76 Clutch Pedal Stroke Sensor Mount Position Error
    

Is DTC C1130-54 or C1130-76 indicated?

     
YES
     
     
     
The failure is duplicated. Go to step 2.
     
NO
     
     
     
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the Freeze data/on-board snapshot.?
2.
Clutch pedal stroke sensor check (substitution):

Clutch pedal stroke sensor check (substitution)
?1.
Turn the vehicle to the OFF (LOCK) mode.

?2.
Substitute a known-good clutch pedal assembly.

?3.
Turn the vehicle to the ON mode.

?4.
Clear the DTC with the HDS.


?5.
Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.

?6.
Check for DTCs with the HDS.
DTC Description
DTC
Freeze Frame
C1130-54 Clutch Stroke Sensor Not Calibrated
    
C1130-76 Clutch Pedal Stroke Sensor Mount Position Error
    

Is DTC C1130-54 or C1130-76 indicated?

     
YES
     
     
     
Check for loose terminals and poor connections in the VSA modulator-control unit 46P connector. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the VSA modulator-control unit.?
     
NO