|
DTC Troubleshooting: B1658
DTC B1658: Rear Bumper LF Antenna Circuit Open
|
DTC Description |
DTC |
|
B1658 Rear Bumper LF Antenna Circuit Open |
| |
|
|
1. |
Problem verification:
Problem verification
|
?1. |
Clear the DTCs with the HDS.
|
|
?2. |
Select the KEYLESS ACCESS CONTROL UNIT from the ONE-PUSH START system select menu with the HDS, and enter the SELF CHECK.
|
|
?4. |
Check for DTCs with the HDS.
|
DTC Description |
DTC |
|
B1658 Rear Bumper LF Antenna Circuit Open |
| |
| | |
Is DTC B1658 indicated?
|
|
|
|
|
|
|
Intermittent failure, the system is OK at this time. Check for loose or poor connections.? |
|
2. |
EXT TR+, EXT TR- line output check:
EXT TR+, EXT TR- line output check
|
?1. |
Turn the vehicle to the OFF (LOCK) mode. |
|
?2. |
Disconnect the following connector.
|
Rear bumper LF antenna 2P connector | |
| |
|
?3. |
Turn the vehicle to the ON mode. |
|
?4. |
Measure the voltage between test points 1 and 2.
|
Test condition |
Vehicle ON mode
Rear bumper LF antenna 2P connector: disconnected |
|
Test point 1 |
Rear bumper LF antenna 2P connector No. 1 |
|
Test point 2 |
Rear bumper LF antenna 2P connector No. 2 | |
|
| |
Is there voltage?
|
3. |
Open wire check (EXT TR+, EXT TR- lines):
Open wire check (EXT TR+, EXT TR- lines)
|
?1. |
Turn the vehicle to the OFF (LOCK) mode. |
|
?2. |
Connect terminals A and B with a jumper wire.
|
Terminal A |
Rear bumper LF antenna 2P connector No. 1 |
|
Terminal B |
Rear bumper LF antenna 2P connector No. 2 | |
|
|
|
?3. |
Disconnect the following connector.
|
Body control module connector F (36P) | |
| |
|
?4. |
Check for continuity between test points 1 and 2.
|
Test condition |
Vehicle OFF (LOCK) mode
Body control module connector F (36P): disconnected
Rear bumper LF antenna 2P connector: disconnected |
|
Test point 1 |
|
|
Test point 2 |
| |
| | |
Is there continuity?
|
|
|
|
|
|
|
Repair an open or high resistance in the wire.? | |