DTC Troubleshooting: P003A, P0046
DTC P003A: Turbocharger Wastegate Control Actuator Position Exceeded Learning Limit
DTC P0046: Turbocharger Wastegate Control Actuator Circuit Range/Performance Problem
NOTE: Before you troubleshoot, review the general troubleshooting information.

DTC Description
Confirmed DTC
Pending DTC
P003A Turbocharger Wastegate Control Actuator Position Exceeded Learning Limit
    
P0046 Turbocharger Wastegate Control Actuator Circuit Range/Performance Problem
    

1.
Problem verification:

Problem verification
?1.
Turn the vehicle to the ON mode.

?2.
Clear the DTC with the HDS.


?3.
Start the engine. Hold the engine speed at 3,000 rpm without load (CVT in P or N, M/T in neutral) until the radiator fan comes on.

?4.
Select the Electric Waste Gate in the INSPECTION MENU with the HDS.

  

?5.
Check for Pending or Confirmed DTCs with the HDS.
DTC Description
Confirmed DTC
Pending DTC
P003A Turbocharger Wastegate Control Actuator Position Exceeded Learning Limit
    
P0046 Turbocharger Wastegate Control Actuator Circuit Range/Performance Problem
    

Is DTC P003A or P0046 indicated?

     
YES
     
     
     
Go to step 2.
     
NO
     
     
     
Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the turbocharger wastegate control actuator and the PCM. If the on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the on-board snapshot.?
2.
Turbocharger check:

Turbocharger check
?1.
Check for the foreign materials at the turbocharger wastegate control actuator link part and the damage on the turbocharger cover.

Is there foreign materials at the turbocharger wastegate control actuator link part or the damage on the turbocharger cover?

     
YES
     
     
     
Repair the turbocharger wastegate control actuator or the turbocharger cover, then go to step 1.?
     
NO
     
     
     
Go to step 3.
3.
Turbocharger wastegate control actuator check:

Turbocharger wastegate control actuator check
?1.
Select the Electric Waste Gate in the INSPECTION MENU with the HDS.

  

?2.
Visually inspect the operation of the turbocharger wastegate control actuator.

Does the turbocharger wastegate control actuator operate?

     
YES
     
     
     
Go to step 4.
     
NO
     
     
     
4.
Determine possible failure area (turbocharger wastegate control actuator position sensor, PCM):

Determine possible failure area (turbocharger wastegate control actuator position sensor, PCM)
?1.
Turn the vehicle to the OFF (LOCK) mode.

?2.
Disconnect the following connector.
Turbocharger 5P connector

?3.
Turn the vehicle to the ON mode.

?4.
Measure the voltage between test points 1 and 2.
Test condition
Vehicle ON mode
 
Turbocharger 5P connector: disconnected
Test point 1
Turbocharger 5P connector (female terminals) No. 2:
Test point 2
Turbocharger 5P connector (female terminals) No. 3:


Is there about 5.0 V?

     
YES
     
     
     
     
NO
     
     
     
The turbocharger wastegate control actuator position sensor is OK. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting, or substitute a known-good PCM, then recheck. If DTC P003A or P0046 goes away and the PCM was substituted, replace the original PCM.?