MIL Circuit Troubleshooting
MIL Circuit Troubleshooting
1.
Gauge control module check:

Gauge control module check
?1.
Turn the vehicle to the ON mode.

?2.
Do the gauge control module self-diagnostic function.

Does the MIL flash?

     
YES
     
     
     
Go to step 2.
     
NO
     
     
     
Substitute a known-good gauge control module, then recheck. If the symptom/indication goes away with a known-good gauge control module, replace the original gauge control module.?
2.
PCM check:

PCM check
?1.
Turn the vehicle to the OFF (LOCK) mode.

?2.
Connect the HDS to the DLC.

?3.
Turn the vehicle to the ON mode.

?4.
Check the parameter(s) below with the HDS.
Signal
Threshold
Current conditions
Values
Unit
Values
Unit
SCS
Short
      

Do the current condition(s) match the threshold?

     
YES
     
     
     
Go to step 3.
     
NO
     
     
     
Check for any authorized service information related to the DTCs or symptoms you are troubleshooting, or substitute a known-good PCM, then recheck. If the symptom/indication goes away and the PCM was substituted, replace the original PCM.?
3.
Shorted wire check (SCS line):

Shorted wire check (SCS line)
?1.
Turn the vehicle to the OFF (LOCK) mode.

?2.
Jump the SCS line with the HDS, and wait more than 1 minute.


?3.
Disconnect the following connector.
PCM connector No. 2 (58P)

?4.
Disconnect the HDS from the DLC.

?5.
Check for continuity between test points 1 and 2.
Test condition
Vehicle OFF (LOCK) mode
 
PCM connector No. 2 (58P): disconnected
Test point 1
PCM connector No. 2 (58P) No. 8
Test point 2
Body ground

Is there continuity?

     
YES
     
     
     
Repair a short in the SCS wire between PCM connector No. 2 terminal No. 8 and the DLC.?
     
NO
     
     
     
The SCS wire is OK. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting, or substitute a known-good PCM, then recheck. If the symptom/indication goes away and the PCM was substituted, replace the original PCM.?