DTC Troubleshooting: P060C
DTC P060C: PCM Internal Control Module Malfunction
NOTE: Before you troubleshoot, review the general troubleshooting information.

DTC Description
Confirmed DTC
Pending DTC
P060C PCM Internal Control Module Malfunction
    

1.
Problem verification:

Problem verification
?1.
Record all the on-board snapshots with the HDS.

?2.
Turn the vehicle to the ON mode.

?3.
Clear the DTC with the HDS.


?4.
Turn the vehicle to the OFF (LOCK) mode.

?5.
Start the engine.

?6.
Test-drive the vehicle for several minutes in the range of these recorded on-board snapshot parameters:
Engine Speed
Vehicle Speed
ECT Sensor 1
MAP Sensor (Hi Res)
REL TP Sensor
Signal
Current conditions
Values
Unit
Engine Speed
    
Vehicle Speed
    
ECT Sensor 1
    
MAP Sensor (Hi Res)
    
REL TP Sensor
    

?7.
Check for Pending or Confirmed DTCs with the HDS.
DTC Description
Confirmed DTC
Pending DTC
P060C PCM Internal Control Module Malfunction
    

Is DTC P060C indicated?

     
YES
     
     
     
The failure is duplicated. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting, or substitute a known-good PCM, then recheck. If DTC P060C goes away and the PCM was substituted, replace the original PCM.?
     
NO
     
     
     
Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the PCM. If the on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the on-board snapshot.?