NOTE: The emergency fuel funnel is stored in the trunk tool box.
?5.
Turn the vehicle to the ON mode.
?6.
Check the parameter(s) below with the HDS.
Signal
Threshold
Current conditions
Values
Unit
Values
Unit
FTP SENSOR
-0.67?0.67
kPa
Do the current condition(s) match the threshold?
YES
Go to step 2.
NO
Go to step 5.
2.
Problem verification:
Problem verification
?1.
Remove the emergency fuel funnel from the fuel filler neck.
?2.
Clear the DTC with the HDS.
?3.
Start the engine, and let it idle without load (in neutral) until the radiator fan comes on.
?4.
Monitor the EVAP PC DUTY (purge control duty) in the DATA LIST with the HDS, while holding the engine speed at 3,000 rpm with the EVAP PC DUTY at 20 % or more for at least 4 minutes, then let the engine idle.
Signal
Current conditions
Values
Unit
EVAP PC DUTY
?5.
Monitor the OBD STATUS for DTC P2422 with the HDS.
If the HDS indicates PASSED, there might be an intermittent failure, and the system is OK at this time. Check the on-board snapshot, and repeat the driving conditions when the DTC set (fuel level, engine speed, vehicle speed, and outside air temperature). If no problem is found, check for poor connections or loose terminals between the FTP sensor and the PCM. Also check for a blockage in the FTP sensor vent port and vent hose, and the EVAP canister vent hose and drain joint. If the HDS indicates NOT COMPLETED, let the engine idle until a result comes on.?