|
Climate Control System Symptom Troubleshooting - The blower and the heater controls and the A/C system do not work
The blower and the heater controls and the A/C system do not work
|
1. |
Fuse check:
Fuse check
|
?1. |
Check the following fuse.
| |
Is the fuse OK?
|
|
|
|
|
|
|
Replace the fuse, and recheck. If the fuse blows again, repair a short in the No. B9 fuse circuit.? |
|
2. |
Open wire check (IG2 A/C (L15B7/K20C2 engine) or IG2 OPTION (L15BA/K20C1/L15BY engine) line):
Open wire check (IG2 A/C (L15B7/K20C2 engine) or IG2 OPTION (L15BA/K20C1/L15BY engine) line)
|
?1. |
Disconnect the following connector.
|
Climate control unit connector A (32P) | |
| |
|
?2. |
Turn the vehicle to the ON mode. |
|
?3. |
Measure the voltage between test points 1 and 2.
|
Test condition |
Vehicle ON mode |
|
Climate control unit connector A (32P): disconnected |
|
Test point 1 |
|
|
Test point 2 |
Body ground | |
| | |
Is there battery voltage?
|
|
|
The IG2 A/C (L15B7/K20C2 engine) or the IG2 OPTION (L15BA/K20C1/L15BY engine) wire is OK. Go to step 3. |
|
|
|
Repair an open in the IG2 A/C wire.? |
|
|
|
|
|
|
NO: L15BA/K20C1/L15BY engine |
|
|
|
|
|
|
|
| |
|
Repair an open in the IG2 OPTION wire.? |
|
3. |
Open wire check (GND line):
Open wire check (GND line)
|
?1. |
Turn the vehicle to the OFF (LOCK) mode. |
|
?2. |
Check for continuity between test points 1 and 2.
|
Test condition |
Vehicle OFF (LOCK) mode |
|
Climate control unit connector A (32P): disconnected |
|
Test point 1 |
|
|
Test point 2 |
Body ground | |
| | |
Is there continuity?
|
|
|
|
|
|
|
Check for an open in the GND wire. If the wire is OK, check for poor ground at G505.? | |