DTC Troubleshooting: P00FE
DTC P00FE: EVAP Vent Line Blockage
Special Tools Required
Vacuum Pump/Gauge, 0?30 inHg Snap-on YA4000A or equivalent, commercially available
NOTE: Before you troubleshoot, review the general troubleshooting information.

DTC Description
Confirmed DTC
Pending DTC
P00FE EVAP Vent Line Blockage
    

1.
Problem verification:

Problem verification
?1.
Turn the vehicle to the ON mode.

?2.
Clear the DTC with the HDS.


?3.
Select the EVAP TEST in the INSPECTION MENU, then select the FUNCTION TEST with the HDS.

  

Is the result OK?

     
YES
     
     
     
Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the FTP sensor, the EVAP canister purge valve, the EVAP canister vent shut valve, and the PCM. If the on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the on-board snapshot.?
     
NO
     
     
     
The failure is duplicated. Go to step 2.
2.
Fuel vent tube visual check:

Fuel vent tube visual check
?1.
Turn the vehicle to the OFF (LOCK) mode.

?2.
Disconnect the fuel vent tube from the fuel tank unit.

?3.
Disconnect the fuel vent tube (A) from the EVAP canister (B), and connect the vacuum pump/gauge, 0?30 inHg (C), to the fuel vent tube as shown.


?4.
Apply vacuum to the fuel vent tube.

Does the tube hold vacuum?

     
YES
     
     
     
Remove the fuel tank, and remove the fuel vent tube. Then visually check the fuel vent tube for deformation, excessive bend, foreign object clogged, or restrictions, and repair or replace it if needed.?
     
NO
     
     
     
Go to step 3.
3.
EVAP canister check:

EVAP canister check
?1.
Connect the hose (A) to the EVAP canister fuel vent tube port (B), and connect the vacuum pump/gauge, 0?30 inHg (C), to the hose as shown.


?2.
Turn the vehicle to the ON mode.

?3.
Apply 1.3 kPa (0.4 inHg, 10 mmHg) of vacuum to the hose.
NOTE: Be careful not to exceed the vacuum. If you do, the FTP sensor can be damaged.

?4.
Check the parameter(s) below with the HDS.
Signal
Current conditions
Values
Unit
FTP Sensor
    

Does the value of FTP Sensor change?

     
YES
     
     
     
     
NO