CVT Driven Pulley Pressure Sensor Removal and Installation (CVT)

CVT Driven Pulley Pressure Sensor Removal and Installation

NOTE: Keep all foreign particles out of the transmission.

1.	Vehicle - Lift

2.	Engine Undercover - Remove

3.	Left Front Splash Shield - Remove

4.	CVT Driven Pulley Pressure Sensor - Remove

Disconnect the connector (A).

NOTE: Check the connector for corrosion, dirt, or oil, and clean or repair if necessary.

Remove the CVT driven pulley pressure sensor (B) with the sealing washer (C).

NOTE: Be careful not to damage the plastic part.

5.	All Removed Parts - Install

Install the parts in the reverse order of removal.

NOTE:

Be sure to use a new sealing washer when installing the CVT driven pulley pressure sensor.