Shift Lever Disassembly and Reassembly
1. Shift Lever Assembly - Exploded View

Exploded View

NOTE: Do not wipe off the special grease applied to the area of the shift lever marked with an asterisk (*).



SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repair or service.

1. Shift Lever Knob Cover - Remove

2. Shift Lever Knob - Remove
NOTE: Do not wipe off the special grease applied to the area of the shift lever marked with an asterisk (*).
1.
Expand the lock tab (A), then remove the shift lever knob (B).

3. Shift Lever Knob Ring - Remove
NOTE: Do not wipe off the special grease applied to the area of the shift lever marked with an asterisk (*).


5. A/T Gear Position Indicator Panel Light Bulb - Remove

6. A/T Gear Position Indicator Panel Light Subharness - Remove

7. Shift Lock Release - Remove
1.
Expand the lock tab (A), then remove the shift lock release (B).

8. A/T Gear Position Indicator Panel - Remove
NOTE: Do not wipe off the special grease applied to the area of the shift lever marked with an asterisk (*).
1.
Expand the lock tabs (A), then remove the A/T gear position indicator panel (B).

9. Select Cover - Remove

10. Shift Lock Unit - Remove
NOTE: Do not wipe off the special grease applied to the area of the shift lever marked with an asterisk (*).
1.
Disconnect the connectors (A).
2.
Remove the harness clamps (A).
3.
Release the lock tab (A) and turn the pivot pin (B) counterclockwise using a hex wrench (C) as shown, and pull it.
4.
Remove the shift lock unit (D) while releasing the lock tabs (E).

11. Shift Lock Solenoid - Remove
NOTE: Do not wipe off the special grease applied to the area of the shift lever marked with an asterisk (*).
1.
Pull the shift lock solenoid (A) out by expanding the lock tabs (B).
2.
Remove the shift lock solenoid (A).
NOTE: The shift lock solenoid consists of the solenoid (B), the solenoid plunger (C), and the plunger spring (D).

12. Shift Lock Stop/Stop Cushion - Remove

13. Park Pin Switch/A/T Gear Position Indicator Panel Light Harness - Remove
NOTE: The park pin switch and the A/T gear position indicator panel light harness are not available separately. Replace the park pin switch and the A/T gear position indicator panel light harness as a set.
1.
Remove the park pin switch (A).
2.
Remove the park pin switch/A/T gear position indicator panel light harness (A).

14. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.