Transmission Housing Driven Pulley Shaft Bearing Replacement
Special Tools Required
Image Description/Tool Number
310156.png Adjustable Bearing Puller, 25?40 mm 07736-A01000B*
310166.png Driver Handle, 40 mm I.D. 07746-0030100
*: 07736-A01000B must be used with commercially available 3/8"-16 slide hammer.

NOTE: Apply a light coat of clean transmission fluid on all parts before installation.

1. Driven Pulley Shaft Bearing - Remove
1.
Remove the bearing set plate (A).
2.
Remove the driven pulley shaft bearing (A) using the 25?40 mm adjustable bearing puller and a commercially available 3/8"-16 slide hammer (B).
3.
Remove the oil guide plate (A).

2. Driven Pulley Shaft Bearing - Install
1.
Install the oil guide plate (A).
2.
Install the driven pulley shaft bearing (A) until it bottoms using the 40 mm I.D. driver handle.
3.
Install the bearing set plate (A).