Forward Clutch Clearance Inspection
Special Tools Required
Image Description/Tool Number
310264.png Clutch Compressor Attachment 07ZAE-PRP0100
9451194.png Clutch Compressor Attachment 64 mm 07ZAE-PRPA110
1. Forward Clutch Clearance - Inspect

1.
Secure the input shaft assembly (A) in a bench vise (B) with wood blocks (C).

NOTE: After this procedure, remove any wood chips that may be stuck to the spline.






2.
Set a dial indicator (A) on the forward clutch end-plate (B).

3.
Zero the dial indicator with the forward clutch end-plate is lifted up to the snap ring (C).

4.
Release the forward clutch end-plate.






5.
Put the clutch compressor attachment and the clutch compressor attachment 64 mm on the forward clutch end-plate (A).

6.
Press the clutch compressor attachment down with 39 N (4.0 kgf, 8.8 lbf) (the weight of the clutch compressor attachment is included) using a force gauge, and read the dial indicator (B).

7.
The dial indicator reads the clearance (C) between the forward clutch end-plate and the top disc (D). Take measurements in at least three places, and use the average as the actual clearance.

Standard:
1.0?1.2 mm (0.039?0.047 in)

8.
If the clearance is out of the standard, replace the input shaft assembly.