Air Mix Control Motor Removal and Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

NOTE: Set the MAX COOL position before removing the air mix control motor.

3. Air Mix Control Motor - Remove
1.
Disconnect the connector (A).
2.
Remove the air mix control motor (B).


SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

NOTE: Set the MAX COOL position before installing the air mix control motor.

1. Air Mix Control Motor - Install


1.
Make sure the air mix door and linkage move smoothly.
2.
Align the air mix control motor (A) with the gear, then install the motor.
3.
Connect the connector (B).
4.
After installation, make sure the motor runs smoothly.