Front Seat Belt Removal and Installation
SRS components are located in this area. Review the
SRS component locations
and the
precautions and procedures
before doing repairs or service.
1.
12 Volt Battery Terminal - Disconnect
NOTE: Wait at least 3 minutes before starting work.
2.
Front Seat Belt Lower Anchor Bolt - Remove
Without outer lap tensioner
With outer lap tensioner
3.
Front Seat Belt Upper Anchor Bolt - Remove
4.
B-Pillar Upper/Lower trim - Remove
5.
Outer Lap Tensioner Bolt - Remove (For Some Models)
1.
Remove the outer lap tensioner bolt (A).
2.
Disconnect the connector (B).
6.
Front Seat Belt Assembly- Remove
Driver's side
Passenger's side
1.
Remove the seat belt assembly (A).
2.
Disconnect the connector(s) (B).
7.
All Removed Parts - Install
Upper anchor bolt installation
Lower anchor bolt installation
Outer lap tensioner bolt installation
1.
Install the parts in the reverse order of removal.
NOTE: Assemble the bushing (A), the collar(s) (B), the toothed lock washer (C), and the plane washer (D) on the bolt (E) as shown.