Cruise Control Combination Switch Removal, Installation, and Test

SRS components are located in this area. Review the SRS component locations, and the precautions and procedures before doing repairs or service.

2. Steering Wheel Trim - Remove
1.
Remove the cases (A).
2.
Remove the screws (A).
3.
Remove the steering wheel trim (A).
4.
Disconnect the connectors (B).

3. Cruise Control Combination Switch - Remove

4. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.

1. Cruise Control Combination Switch - Test
1.
Measure the resistance between cruise control combination switch 12P connector terminals No. 2 and No. 5 according to the table.
If there is no resistance in one or more positions, replace the cruise control combination switch.
Position
Resistance
OFF
About 2.2 k?
CRUISE (PRESSED)
About 60 ?
CANCEL (PRESSED)
About 190 ?
SET- (PRESSED)
About 450 ?
RES+ (PRESSED)
About 900 ?
2.
Check the LED for illumination when connecting battery power and ground to the switch terminals according to the table.
NOTE: Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).
If the results are not as specified, replace the cruise control combination switch.