Carefully pry off the cargo area light (A) to the side to release the hook and pull out the light.
2.
Disconnect the connector (B).
3.
Remove the bulb (C) from the cargo area light.
2.
All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
1.
Cargo Area Light - Test
NOTE: When doing the cargo area light test, make sure to install the bulb correctly.
1.
Check for continuity between the terminals No. 2 and No. 1 according to the table.
NOTE:
Make sure the correct test lead (?or ?) is placed on the terminal.
When checking for continuity across the diode, use the diode setting () on the digital volt/ohm meter to check the diode bias.
Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).
2.
If the continuity is not as specified, replace the bulb or the cargo area light (A).
