Wiper/Washer Switch Removal, Installation, and Test
SRS components are located in this area. Review the
SRS component locations
and the
precautions and procedures
before doing repairs or service.
1.
Column Cover - Remove
2.
Wiper/Washer Switch - Remove
1.
Disconnect the connector (A).
2.
Remove the wiper/washer switch (B) by pressing the tabs.
3.
All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
1.
Wiper/Washer Switch - Test
Windshield
Rear window
1.
Inspect the connector terminals to be sure they are all making good contact.
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
If the terminals are OK, go to step 2.
2.
Check for continuity between the terminals in each switch position according to the table.
3.
If the continuity is not as specified, replace the wiper/washer switch (A).
