Blower Resistor Test

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

1.	Passenger's Dashboard Undercover - Remove

2.	Glove Box - Remove

3.	Blower Resistor - Test

Disconnect the blower resistor connector.

Measure the resistance between the following terminals of the blower resistor and compare them with the values in the table.

NOTE: Also check the blower motor. Blower resistor failure can be caused by a defective blower motor.

If the resistance is not within the specifications, replace the blower resistor.

4.	All Removed Parts - Install

Install the parts in the reverse order of removal.