Front Impact Sensor Removal and Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.


NOTE: Wait at least 3 minutes before starting work.

3. Front Impact Sensor - Remove
1.
Disconnect the connector (A).
2.
Remove the TORX bolt (B) using a TORX T30 bit, then remove the front impact sensor (C).

4. All Removed Parts - Install
1.
Install the all removed parts in the reverse order of removal.
NOTE:
During installation, install the new TORX bolt to the specified torque.
Before installing the front inner fender, make sure the SRS indicator works normally.

5. SRS Operation - Confirm
1.
Do the 12 volt battery terminal reconnection procedure, turn the vehicle to the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.